Reference Guide

466
Tools
Using tools to perform common tasks
To move envelope nodes
1. Set the track’s Edit Filter control to the desired automation parameter (Track Automation or
Clip Automation).
2. Do one of the following:
• With the Smart tool , drag the node to the desired location.
• With the Move tool , drag the node to the desired location.
• With the Trim tool , drag the node to the desired location.
To reset envelope nodes
1. Set the track’s Edit Filter control to the desired automation parameter (Track Automation or
Clip Automation).
2. Do one of the following:
• With the Smart tool , double-click the node.
• With the Move tool , double-click the node.
• With the Trim tool , double-click the node.
To raise/lower selected envelope nodes
1. Set the track’s Edit Filter control to the desired automation parameter (Track Automation or
Clip Automation).
2. Do one of the following:
• With the Smart tool , position the pointer near the top center of the track/clip, then drag up/
down.
• With the Trim tool , position the pointer near the top center of the track/clip, then drag up/
down.
To draw automation freehand
1. Set the track’s Edit Filter control to the desired automation parameter (Track Automation or
Clip Automation).
2. With the Freehand tool , drag to insert envelope nodes and segments.