Reference Guide

485

Control Bar overview

“Screenset module” on page 490

“Performance module” on page 492

“Punch module” on page 494

“Select module” on page 495

“Markers module” on page 496

“Event Inspector module” on page 498

“Sync Module” on page 499

Loop module

The Loop module lets you control loop settings.

To show/hide the Loop module

Right-click the Control Bar and select Loop Module.

Figure 152. The Loop module.

A. Loop On/Off B. Set Loop Time to Select C. Loop Start Time D. Loop End Time

The Loop module contains the following controls:

• Loop on/off . Enable/disable playback looping.

• Set Loop Times to Selection . Set the Loop Start time to the start (From) time of the

selection, and the Loop End time to the end (Thru) time of the selection.

• Loop Start Time. The current Loop Start time. Click to modify.

• Loop End Time. The current Loop End time. Click to modify.

See:

“Loop recording” on page 281

“Looping” on page 185

Tip:

If a numeric time field has focus, you can press the G key to access a list of marker positions.