Reference Guide

499
Control Bar overview
See also:
“Tools module” on page 476
“Snap module” on page 480
“Transport module” on page 482
“Loop module” on page 485
“Mix module” on page 486
“ACT module” on page 488
“Screenset module” on page 490
“Performance module” on page 492
“Punch module” on page 494
“Select module” on page 495
“Markers module” on page 496
“Sync Module” on page 499
Sync Module
The Sync module lets you configure synchronization settings.
To show/hide the Sync module
Right-click the Control Bar and select Sync Module.
Figure 161. The Sync module.
A. SMPTE/MTC format B. Incoming timecode C. Sync type D. Transmit MIDI Sync E. Transmit MTC Sync
The Sync module contains the following controls:
• SMPTE/MTC format. Select the time code format. The following frame rates are supported:
• 24 frames per second (FPS). Used for theatrical film worldwide. Any film in North America
or Japan uses this setting.
• 25 FPS. Used for PAL/SECAM video and some film in countries that use 50 Hz wall
electricity. This is the setting to use when synchronizing to any European video format.
C D E
B
A