Reference Guide

654
Editing MIDI events and continuous controllers (CC)
Event Inspector
Event Inspector
The Event Inspector module is available in the Control Bar. The Event Inspector has the following:
•Time
•Pitch
•Velocity
• Duration
• Channel
Figure 208. The Event Inspector module.
A. Time B. Duration C. Pitch D. Velocity E. Channel
To display a note’s properties in the Event Inspector
• Select a note.
If you select multiple notes, the Event Inspector displays the note value if all selected note values
are the same. If the note values are different, the Event Inspector does not display anything.
To change a note’s properties using the Event Inspector
1. Select a note.
2. In the appropriate Event Inspector field, change the value. See the table below for a description
of valid value entries for each field in the Event Inspector.
Event Inspector Field Valid Values
Time Any valid M:B:T time value. Separate values with a colon or a space. For
example, measure 2, Beat 3, Tick 720 would be written as 2:3:720.
Pitch Note names (C0 through G10) and note numbers (0 through 127) are valid in
this field. Also, you can use a modifier to raise or lower the value by a number of
half-steps. To raise the pitch by 2 half-steps, type +2 and press enter. To lower
the pitch by 2 half-steps, type -2 and press enter.
Table 121.
A
C
B
D E