Reference Guide

928
ProChannel (Producer only)
To reorder the signal chain
Drag the corresponding icons in the Routing display until the modules appear in the desired order.
Figure 268. Drag the module icons to reorder the effect chain.
A. Equalizer B. Compressor C. Tube saturation
To interact with the Equalizer graph
The Equalizer graph is divided into four sections, which correspond to the Low, Low-Mid, Mid-High
and High bands. When you move the mouse pointer over the graph, the current band is highlighted.
To adjust a band’s gain, drag up/down.
To adjust a band’s frequency, drag left/right.
To adjust a band’s Q, hold down the ALT key and drag up/down.
To adjust parameters with finer precision, hold down the SHIFT key while dragging.
To enable/disable a band, click the band’s region in the graph.
To change the plot resolution globally, right-click any Equalizer graph in the Console view and
choose the desired resolution on the pop-up menu. The resolutions are as follows:
• Auto (graph scales dynamically)
•6 dB
• 12 dB
• 18 dB
Figure 269. Equalizer graph.
A. Low band B. Low-Mid band C. Mid-High band D. High band
Note: The High Pass filter and Low Pass filter can not be edited from the graph.
A B C
DCBA