Reference Guide

952
Automation
Automation methods
To select automation
1. Set the track’s Edit Filter control to the desired automation parameter (Track Automation or
Clip Automation).
2. Do one of the following:
• With the Smart tool , position the pointer over the bottom half of the track/clip, then drag
left/right to select a range of envelope nodes.
• With the Smart tool , position the pointer outside any existing envelopes, then drag over the
envelopes nodes you want to select.
• With the Select tool , click the node. Hold CTRL or SHIFT to extend the selection.
• With the Select tool , position the pointer outside any existing envelopes, then drag over
the envelopes nodes you want to select.
To move automation
1. Set the track’s Edit Filter control to the desired automation parameter (Track Automation or
Clip Automation).
2. Do one of the following:
• With the Smart tool , position the pointer over the envelope segment you want to move,
then drag the segment to the desired location.
• With the Move tool , position the pointer over the envelope segment you want to move,
then drag the segment to the desired location.
• With the Trim tool , position the pointer over the envelope segment you want to move, then
drag the segment to the desired location.
To add envelope nodes
1. Set the track’s Edit Filter control to the desired automation parameter (Track Automation or
Clip Automation).
2. Do one of the following:
• With the Smart tool , position the pointer over the envelope where you want to insert a new
node, then double-click.
• With the Smart tool , position the pointer over the envelope where you want to insert a new
node, then hold down the ALT key and click.