Reference Guide

1032 Automation
Creating and editing automation envelopes
mode to 100% right, then the pan parameter is now set to hard right. Setting the pan in offset mode
to 50% right would set the pan to the center.
To enable/disable Offset mode
Do one of the following:
• Click the Offset mode button in the Control Bar’s Mix module.
• Press O.
In Offset mode, all controls that can be offset appear with a plus sign. For example Vol+.
The following audio controls support both Envelope and Offset modes:
Note: Any position that you set a fader to in Offset mode remains in effect when you switch back
to Envelope mode. For example, if you set a volume fader to -INF while in Offset mode, switch
to Envelope mode and drag the fader to its maximum level, you will not hear anything.
Control Envelope Mode Range Offset Mode Range
Volume -Infinity to +6dB, default is 0dB -Infinity to +6dB, default is 0dB
Pan 100% L to 100% R, default is C 100% L to 100% R, default is C
Bus Send Level -Infinity to +6dB, default is 0 dB -Infinity to +6dB, default is 0dB
Bus Send Pan 100% L to 100% R, default is C 100% L to 100% R, default is C
Bus Return Level -Infinity to +6dB, default is 0dB -Infinity to +6dB, default is 0dB
Bus Return Balance 100% L to 100% R, default is C 100% L to 100% R, default is C
Main Out Volume -Infinity to +6dB, default is 0dB -Infinity to +6dB, default is 0dB
Main Out Balance 100% L to 100% R, default is C 100% L to 100% R, default is C
Table 182.