Reference Guide

1087
Basic musical editing
Notation and lyrics
Here’s what the Staff view looks like with and without these options:
Figure 331. Fill and Trim off
Figure 332. Fill and Trim on
On the other hand, if you are entering notes into the Staff view with the mouse, Fill Durations and
Trim Durations may produce confusing results. For example, with Fill Durations, an inserted
eighth note in 4/4 time would look like a quarter note until you insert another eighth note immediately
following it. It is recommended that you turn off the Fill Durations and Trim Durations options when
entering notes; these options are more appropriate for looking at notes you recorded via a
performance.
Using enharmonic spellings
Any musical note can be referred to by several different names. For example, C#3 and Db3 identify
the same pitch, as do G#4 and Ab4. The most appropriate name depends upon the current key
signature, but can also depend on musical context.
SONAR uses a set of rules to automatically add accidentals (sharps, flats and naturals) to notes
based on the current key signature. These rules cover the most common musical situations and
usually lead to pleasing results. However, there is no guaranteed right way to resolve accidentals.
Doing so ultimately requires knowledge regarding what key or scale is being evoked—knowledge
that only the composer possesses. For example, if a modulation is being prepared, then the new key
signature has not yet been completely established, and the harmony has already begun to shift. In
fact, there may not even be a scale in a diatonic sense: chromatic scales, for instance, are supposed
to sharp on the way up and flat on the way down. Because no set of rules will suffice for all
situations, the composer needs the ability to override any default choice.
Notes in SONAR normally do not have a forced enharmonic spelling. This means that they will
automatically change to match the default for a new key signature. If you specify spelling that
matches the default choice, SONAR will drop any forced spelling and switch back to default
behavior. Otherwise, the forced spelling is remembered for that note, and will not change to follow
the key signature. If you change the pitch of a note by some other means (for instance, by dragging
it up or down), it will lose any forced spelling, because it very likely no longer applies to the new
pitch. Enharmonic spelling overrides for each note are saved in the project file.
When you type a note’s enharmonic spelling, use the following table as a guide.