Reference Guide

1231
Euphonix EuCon control surface support
External devices
Euphonix EuCon control surface support
SONAR supports the Euphonix EuCon protocol, which allows SONAR to be controlled by Euphonix
surfaces such as the MC and CM408 series.
To enable EuCon support in SONAR
1. Follow your Euphonix surface’s instructions for physically connecting the Euphonix surface to
your computer and configure the Euphonix software.
2. In SONAR, go to Edit > Preferences > MIDI - Control Surfaces.
3. Click the Add Controller/Surface button , which opens the Controller/Surface Settings
dialog box.
4. In the Controller/Surface field of the Controller/Surface Settings dialog box, select EuCon
Controller.
5. Click OK to close the Controller/Surface Settings dialog box.
6. In the Preferences dialog box (MIDI - Control Surfaces page), make sure that the WAI Display
check boxes and the ACT Indicators check boxes are enabled, and click OK.
For more information about using the EuCon Controller surface, see the separate EuCon Controller
online Help (open the EuCon Controller plug-in and press F1).
See also:
“To connect a controller/surface to SONAR” on page 1214
Note: It is not necessary to select any input or output ports.