Reference Guide

1241
Working with StudioWare
External devices
The initial range for each control is set based on the position of the controls at the time you group
them.
You can adjust the range for any individual control, even if it is part of a group, simply by holding the
SHIFT key while you move the control. When you adjust an individual control by holding the SHIFT
key, its maximum or minimum is adjusted, depending on whether the entire group is closer to its
minimum or maximum value.
To create a group of controls
1. Select any control by clicking on it with the mouse.
2. Hold down the CTRL key and click on one or more additional controls.
SONAR creates a group from the selected controls.
To remove controls from a group
Hold down the CTRL key and click on any control in the group.
SONAR removes the control from the group.
To adjust a single control in a group
Hold down the SHIFT key and drag the control to a new value.
The range for the control is adjusted so that its current position corresponds with the current position
of other controls in the group.
Example: to set two faders for a crossfade
1. Move the two faders to their midpoint.
2. Click on the first fader, and then CTRL-click on the second to create a group.
3. Move both faders to their highest position.
4. SHIFT-drag the second fader to its lowest position.
5. Drag the first fader to its lowest position.
6. SHIFT-drag the second fader to its highest position.
These two controls are now grouped so that they move in opposite directions.