Reference Guide

1245
Working with StudioWare
External devices
To record a snapshot while playback is stopped
1. Set the Now time to the point in the project where you want the settings to take effect.
2. Move the controls to the settings you desire.
3. Click .
SONAR records a snapshot of the current control settings.
If the Now time is the very beginning of the project, then the snapshot will change the track
parameters to match the controls in the panel instead of recording automation events.
To record a snapshot while playback is in progress
1. Make sure the button in the StudioWare toolbar is not pressed so that Update is disabled.
2. Change the Now time to a few bars or seconds before the time you want to take the snapshot.
3. Start playback.
4. When you have reached the appropriate time, click on the Snapshot button.
SONAR records a snapshot of the current control settings.
To record control changes in real-time
1. Make sure the button in the StudioWare toolbar is pressed so that Update is enabled.
2. Make sure the button in the StudioWare toolbar is pressed so that Recording is enabled.
3. Set the Now time to a few bars or seconds before the time at which you want to record control
movements.
4. Click or press SPACEBAR to start playback.
5. Adjust the controls as you want while playback is in progress. Each time you adjust a control, the
Record tool is activated.
6. When you are done, click or press the SPACEBAR to stop playback.
7. Click the button in the StudioWare toolbar to turn off real-time recording.
SONAR records the control changes that you entered while playback was in progress.
Note: Do not press the Record button in the Control Bar’s Transport module!