Reference Guide

1399

Cyclone

Loop bin

The Loop bin, located right below the Cyclone toolbar, is where you can place loops you want to use

in Cyclone. From the Loop bin you can drag and drop loops onto a Pad or into the Pad Editor.

A. Current Loop B. Loops C. Click to delete selected loop D. Click to load a loop

Loop view and Key Map view

The Loop view displays the content of the loop you have selected in the Loop bin. If the loop is an

ACIDized loop, the loop’s transient markers separate the file’s slices. From the Loop view, you can

drag a slice onto an event in the Pad Editor.

Tails The tails feature extends the “tail” or decay of a slice which may otherwise have

ended prematurely, drowned out by the next slice. This is particularly useful when

you substitute a longer slice with a shorter one leaving room for a tail to sound.

Latch The Latch option gives you a second mode for triggering pads. In Latch mode, a

Groove Clip plays continuously when triggered until it is triggered again. With Latch

mode disabled, a pad only plays as long as the key or mouse button is held and

stops when you release. If you want to set all pads to the same Latch state, hold

down the SHIFT key while setting the Latch for any one pad.

Pitch Markers This option forces Cyclone to follow SONAR’s Pitch markers. When a Pitch marker

is encountered, the loop is transposed by the same number of semi-tones as the

pitch change in SONAR.

Control Description

Table 234.