Reference Guide

1421
Groove Clip Looping
Menu reference
Groove Clip Looping
The Groove Clip Looping command enables a selected audio clip’s looping capabilities. When you
enable these capabilities, you can make unlimited copies of the clip by dragging its start or end
points to the left or right, respectively. When a clip’s looping capabilities are enabled, the clip’s
corners are beveled instead of sharp. If the clip’s looping capabilities are already enabled, the same
command turns them off.
For more information, see “Working with loops and Groove Clips” on page 651.
Clip Mute/Unmute
This command mutes or unmutes all selected clips.
Split
The Split command opens the “Split Clips dialog” on page 1757, which allows you to split a selected
clip into smaller clips.
Split Clip(s) at AudioSnap Pool
The Split Clip(s) at AudioSnap Pool command splits selected clips at AudioSnap pool lines.
Clip Lock > Lock Position
Using the Clip Lock > Lock Position command locks or unlocks a clip’s position.
For more information, see “Locking Clips” on page 343.
Clip Lock > Lock Data
Using the Clip Lock > Lock Data command locks or unlocks a clip’s data.
For more information, see “Locking Clips” on page 343.