Reference Guide

361
Markers and the snap grid
Arranging and editing
To jump to a marker
There are many different ways to jump to a specific marker:
• Choose a marker from the drop-down list in the Control Bar’s Markers module.
• Press G twice to display a list of markers, choose the marker you want, and click OK.
• Click on a marker in the Markers view to set the Now time to that marker.
• Click the Next Marker button or Previous Marker button in the Markers module.
• Press CTRL+SHIFT+PAGE DOWN to jump to the next marker, or press CTRL+SHIFT+PAGE UP
to jump to the previous marker.
To select a time range using markers
You can select a range of times by clicking in the marker section of the Time Ruler:
• Click to the left of the first marker to select the time between the start of the project and the first
marker.
• Click to the right of the last marker to select the time between the marker and the end of the
project.
• Click between two markers to select the time between the markers.
• If looping is enabled, click to the right of the Loop Start marker to select the loop region
• If punch recording is enabled, click to the right of the Punch In marker to select the punch region
Tip: If you press TAB or right-click while holding down the left mouse button over the markers, you
can toggle through which of the overlaid markers you'd like to move.
For example, if the Now Time marker, a regular Marker, a Loop point, and a Punch point are all at
measure 5, pressing Tab (while holding down the left mouse button) toggles through T (Now Time),
M (regular), L (Loop), and P (Punch). If you want to change the regular marker, simply drag the
mouse when M is displayed; if you want to adjust the position of the Loop point, tab through to L, and
so on.