Reference Guide

475
Using tools to perform common tasks
Tools
Working with AudioSnap transients
• “To select transient markers” on page 492
• “To move transient markers (without stretching audio)” on page 492
• “To stretch transients” on page 492
• “To promote transient markers” on page 493
• “To erase transient markers” on page 493
• “To split an audio clip at transient markers” on page 493
• “To add transient” on page 494
Working with audio clips
To fade in/out an audio clip
1. Set the track’s Edit Filter control to Clips.
2. Do one of the following:
• With the Smart tool , position the pointer in the top left (fade in) or top right (fade out)
corner of the clip, then drag to adjust the fade duration.
• With the Edit tool , position the pointer in the top left (fade in) or top right (fade out) corner
of the clip, then drag to adjust the fade duration.
To crop a clip’s start/end
1. Set the track’s Edit Filter control to Clips.
2. Do one of the following:
• With the Smart tool , position the pointer over the clip’s start or end point, then drag to
adjust the start/end position.
• With the Edit tool , position the pointer over the clip’s start or end point, then drag to adjust
the start/end position.
Tip: When cropping clips, you can choose to also move clip fades proportionally, or retain the original
fade position. To move the fade position, click the top three quarters of the clip edge when cropping.
To retain the clip fade position, click the bottom quarter of the clip edge when cropping. You can also
hold down the ALT key while cropping in order to move a clip fade.