Reference Guide

476 Tools
Using tools to perform common tasks
To move data and the clip edge
1. Set the track’s Edit Filter control to Clips.
2. Do one of the following:
• With the Smart tool , position the pointer over the clip’s start or end point, then hold
ALT+SHIFT and drag to adjust the start/end position.
• With the Edit tool , position the pointer over the clip’s start or end point, then hold
ALT+SHIFT and drag to adjust the start/end position.
To move data without moving its clip
1. Set the track’s Edit Filter control to Clips.
2. Do one of the following:
• With the Smart tool , position the pointer within the clip, then hold ALT+SHIFT and drag
left/right to move the data within the clip boundaries.
• With the Edit tool , position the pointer within the clip, then hold ALT+SHIFT and drag left/
right to move the data within the clip boundaries.
To select audio clips
1. Set the track’s Edit Filter control to Clips.
2. Do one of the following:
• With the Smart tool , position the pointer over the clip, then click to select the clip.
• With the Smart tool , position the pointer below the clip header, then drag to make a time
selection.
• With the Smart tool , position the pointer outside any clips, then drag to make a time
selection.
• With the Smart tool , drag with the right mouse button to lasso the clips you want to select.
It is sufficient to simply touch the clips you want to select; there is no need to fully enclose the
clips.
• With the Select tool , position the pointer outside any clips, then drag over the clips you
want to select.
• With the Select tool , position the pointer over the clip, then click to select the clip.