Reference Guide

509

Control Bar overview

Mix module

The Mix module lets you configure various playback settings. You can quickly mute/unmute, solo/

unsolo and arm/disarm all tracks. You can also configure automation settings and specify the solo

behavior.

To show/hide the Mix module

Right-click the Control Bar and select Mix Module.

Figure 158. The Mix module.

A. Mute B. Solo C. Arm D. Input Echo E. Live Input PDC Override F. Bypass All Effects G. Exclusive Solo

H. Dim Solo I. Automation Read (playback) J. Automation Write (recording) K. Offset mode

The Mix module contains the following controls:

• Mute / Unmute All Tracks . Click to mute/unmute all tracks. The button is lit if at least one

track is muted.

• Solo / Unsolo All Tracks . Click to solo/unsolo all tracks. The button is lit if at least one

track is soloed.

• Dim Solo enable/disable . Enable/disable Dim Solo mode. Dim Solo is a mode in which

non-soloed audio tracks/buses are still audible but at a reduced level. For details, see “Dim

Solo mode” on page 200.

• Exclusive Solo enable/disable . Enable/disable Exclusive Solo mode. With Exclusive

Solo mode, you can only solo one track and one bus at a time. For details, see “Exclusive

Solo mode” on page 201.

• Arm / Disarm All Tracks . Click to arm/disarm all tracks. The button is lit if at least one track

is armed.

• Input Echo On/Off All Tracks . Enable/disable Input Monitoring on all tracks.

• Bypass all Effects . Bypass all effects globally. For details, see “Bypassing effects globally”

on page 869.

• Live Input PDC Override . Enable/disable delay compensation on live tracks, thereby

removing the latency during playback and recording of such tracks. Because it's a toggle, you can

quickly turn it on to complete your tracking at low latency, and turn it off when finished to hear the

A B C D

I JG