Reference Guide

516 Control Bar overview
Punch module
The Punch module lets you control auto-punch settings.
To show/hide the Punch module
Right-click the Control Bar and select Punch module.
Figure 162. The Punch module.
A. Auto-Punch On/Off B. Set Punch Time to Select C. Punch In Time D. Punch Out Time
The Punch module contains the following controls:
• Auto-Punch on/off . Enable/disable punch recording. Toggles punch recording on/off.
• Set Punch Time to Selection . Set the Punch In time to the start (From) time of the
selection, and the Punch Out time to the end (Thru) time of the selection.
• Punch In Time. The current Punch In time. Click to modify.
• Punch Out Time. The current Punch Out time. Click to modify.
See:
“Punch recording” on page 288
See also:
“Tools module” on page 498
“Snap module” on page 502
“Transport module” on page 504
“Loop module” on page 507
“Mix module” on page 509
“ACT module” on page 511
“Screenset module” on page 512
Tip: If a numeric time field has focus, you can press G to access a list of marker positions.
A
B
C
D