Reference Guide

605
Editing transient markers
AudioSnap (Producer and Studio only)
“Synchronizing audio and the project tempo” on page 610
“Extracting MIDI timing information from audio” on page 633
“General editing” on page 635
“Using the Pool” on page 643
“Algorithms and rendering” on page 646
Enabling/disabling AudioSnap
You can enable/disable AudioSnap processing on a clip-by-clip basis. Transient markers are always
available to be edited, but AudioSnap is not active on a clip unless at least one transient marker has
been stretched.
By disabling AudioSnap on a clip that has stretched transient markers, you can compare how the
clip sounds with and without AudioSnap processing. Disabling AudioSnap can also temporarily free
up CPU processing power.
To enable or disable AudioSnap
1. Select the audio clips you want to enable/disable AudioSnap on.
2. Do one of the following:
• Click the Bypass button in the AudioSnap palette.
• Click the Enable check box in the Clip Inspector’s AudioSnap section.
AudioSnap is enabled/disabled on the selected audio clips, and transient markers are shown/
hidden.
See:
“Using global tools on AudioSnap transient markers” on page 592
“Using the AudioSnap palette” on page 606
“Fixing timing problems in audio clips” on page 617
“Synchronizing audio and the project tempo” on page 610
“Extracting MIDI timing information from audio” on page 633
“General editing” on page 635
“Using the Pool” on page 643
“Algorithms and rendering” on page 646
Note: AudioSnap is automatically enabled on a clip if you stretch a transient marker on the clip.