Reference Guide

890 Mixing

Effects chains

To add/remove an assignable knob or button (Producer only)

Right-click the FX Chain property page and choose one of the following commands on the pop-up

menu:

• Add knob. Add a new assignable knob, up to a total of 6 knobs.

• Add button. Add a new assignable button, up to a total of 6 knobs.

• Remove control. Remove the assignable control.

• Learn knob/button. The FX Chain is put into a learning mode and will 'listen' to controls

touched on the plug-ins in the FX Chain. When you select Learn knob/button again, the touched

controls are assigned and displayed in the FX Chain property page. Learn mode is automatically

ended if the limit of 6 buttons or knobs is reached, or when the limit of 4 parameters for a knob or

button is reached.

To customize an assignable control (Producer only)

Right-click a knob or button in the FX Chain property page and choose Edit control on the pop-up

menu to open the Control Properties dialog box.

Figure 268. Assignable control properties.

A. Name B. Position C. Destination D. Start value E. End value

Note: If you right-click an existing knob/button, that knob/button is reset and re-learned,

otherwise a new knob or button is created (up to a maximum of 6 buttons or knobs).