Reference Guide

912 Mixing
Using the per-track EQ (Studio and Essential only)
To show or hide the EQ in all audio tracks
• In the Console view, click the Modules menu and choose EQ Plot.
• In the Track Inspector, click the Display button and choose EQ Plot.
To enable or disable the EQ in a track or bus
• Double-click the EQ plot to open the EQ interface, then enable/disable the desired bands.
To configure the EQ
• Double-click the track’s EQ plot to open the Sonitus fx: EQ property page. Please see the Sonitus
fx: EQ online Help for detailed information.
To change the plot resolution
• Right-click the EQ plot and choose the desired plot resolution on the pop-up menu.
To copy EQ settings
SONAR lets you easily copy EQ settings from one track/bus (source) to another track/bus (target)
when using the integrated per-channel EQ in the Console View or Track Inspector.
To do so, hold down the CTRL, click the source EQ plot and drag to the target EQ plot, then release
the mouse button and CTRL key.
The EQ settings are copied from the source track/bus to the target track/bus. The target EQ will
automatically be enabled if it was not already enabled.
This command is undoable, so you can quickly and easily revert to a track/bus’ previous EQ
settings.
A. Hold down the CTRL key and left-click in the source EQ plot B. While still holding down the CTRL key and left
mouse button, drag the mouse cursor to the target EQ plot and release the mouse button C. The source EQ plot
is copied to the target EQ plot
Note: You can only copy settings from an EQ that is enabled.
B
C
A
Before copy After copy