Reference Guide

952 Surround Mixing (Producer and Studio only)

Panning in surround

To change the front/rear balance

• In the large surround panner, drag the FrntRrBl slider left to reduce front level, or right to reduce

rear level.

To change the LFE send level

• In either the large or small surround panner, drag the LFE slider.

To solo or unsolo the LFE channel

• In the large surround panner, click the LFE Solo button.

To isolate a signal in one speaker

• In the large surround panner, drag the Width slider to 0, the Focus slider to 100, and then drag

the Angle slider until the sphere icon is directly in front of the correct speaker.

• Press the desired Numeric Keypad key that represents the speaker position (7=L, 8=C, 9=R, see

“Keyboard shortcuts” on page 953).

To group panner controls

• In the large surround panner, right-click each slider that you want to add to the group, and choose

Group-”n” from the pop-up menu.

Now you can move a single slider, and all sliders in that same group move synchronously.

Note: Double-clicking any surround panner control will reset the control to its default value,

which for the LFE control is -INF.

Note: If you group sliders that are in the same surround panner, you can no longer move the

markers that represent those sliders’ values. You can only move a grouped marker by moving

its associated slider.