Reference Guide

971
ProChannel (Producer only)
Loading X2 projects in SONAR X1c or earlier
• SONAR X1c and earlier only support a single compressor module per channel. If you are using
multiple compressor modules on a channel in a SONAR X2 project, SONAR X1c (or earlier) will
only load one of the compressors.
• SONAR X1c and earlier always shows the Compressor, Equalizer and Tube Saturation modules
on all channels. If you load a SONAR X2 project that doesn’t use all the default modules, SONAR
X1c will automatically recreate the missing modules.
• If you load a SONAR X2 project that has ProChannel Global Bypass enabled, you will not be able
to unbypass that ProChannel instance in SONAR X1c.
See:
“ProChannel modules and controls” on page 971
“PC76 U-Type Channel Compressor module” on page 977
“PC4K S-Type Bus Compressor module” on page 979
“QuadCurve Equalizer module” on page 981
“Tube Saturation module” on page 987
“Console Emulator module” on page 988
“FX Chain module” on page 992
See also:
“Track Inspector overview” on page 529
“Console view” on page 1836
“Mixing” on page 829
ProChannel modules and controls
ProChannel can be displayed either collapsed or expanded in the Inspector and Console view.
When collapsed, only a subset of all available controls are visible.
Note: When expanding ProChannel in the Inspector, ProChannel fills the entire width of the
Inspector. When expanding ProChannel in the Console view, ProChannel extends to the right
of the channel strip.