Install guide

CalAmp | LenderOutlook Device Install Guide
5.4.3 PAYMENT REMINDER AND NOTIFICATION
The LMU-7XX and LMU-8XX use the optional Output #2 to send a 30 second sink to ground through the
Yellow wire of the LMU-XXX wiring harness to the Piezo Buzzer (4C765).
Figure 12: Piezo Buzzer Connection
1. The buzzer may come with a connector on the end and/or resistors spliced into the wire near the
buzzer. Remove the connector, cutting just outside the connector surface, being careful to leave
any resistors intact on the buzzer harness.
2. Connect the Red Wire from the Piezo Buzzer to White Ignition Power wire. The White ignition wire
must also be connected to the vehicle ignition wire. An additional length of 22AWG wire may be
needed.
3. Connect the Black Wire from the Piezo Buzzer to the appropriate wire for each device according to
the device wiring table
.
Figure 13: Optional Payment Reminder Wiring
MBUD-0266v1.3 Page 21