Install guide

CalAmp | LenderOutlook Device Install Guide
Figure 16: Sealant Applied to Backside
5. Apply RTV sealant inside the mounting holes.
6. Feed mounting screws from inside.
7. Mount device on screws and tighten nuts.
• Caution: Drive screws at low speed to avoid seizing.
8. Remove the activation magnet from the front of the device.
• The activation magnet interrupts power to the device. In order to activate device reporting, you
must remove the activation magnet.
• Retain the activation magnet in order to disable reporting unit upon de-installation of device.
• End of installation procedure.
Page 28 MBUD-0266v1.3