Install guide

CalAmp | LenderOutlook Device Install Guide
7.1 CAT-720 BATTERY REPLACEMENT
The following steps outline the procedure to remove and replace the CAT-720 battery pack.
To Replace the CAT-720 Battery:
1. Remove Battery Cap.
Figure 17: Remove Battery Cap
2. Insert Phillips head screw driver and remove the four (4) screws.
3. Remove the end cap and set aside.
4. Disconnect power cable.
5. Remove the rubber gasket and set aside.
Figure 18: Disconnect the Battery Connector
6. Disconnect the red and black power cable by pulling two connectors apart.
• Do not pull on the power wires.
MBUD-0266v1.3 Page 29