Install guide

CalAmp | LenderOutlook Device Install Guide
LIST OF FIGURES
Figure 1: CalAmp LMU-XXX Device ..................................................................................................... 5
Figure 2: Coil Excess Cable ............................................................................................................... 12
Figure 3: Tamper Resistant Materials............................................................................................... 13
Figure 4: Acceptable (Yellow) and Poor (Red) locations for device placement. ................................. 15
Figure 5: LMU-XXX Example Mount ................................................................................................. 16
Figure 6: OBD-II Harness .................................................................................................................. 17
Figure 7: Connect Power and Ground using supplied connectors ..................................................... 17
Figure 8: Vehicle OBD-II Port Connector and OBD-II Flange Mounted .............................................. 17
Figure 9: Plugged OBD-II Connectors and Taped Connectors ............................................................ 18
Figure 10: Re-mounted OBD-II Port Connector ................................................................................ 18
Figure 11: Optional Starter Disable Relay and Socket ....................................................................... 19
Figure 12: Piezo Buzzer Connection ................................................................................................. 21
Figure 13: Optional Payment Reminder Wiring ................................................................................ 21
Figure 14: CAT-720 .......................................................................................................................... 24
Figure 15: Example CAT-720 Installation (Previous model shown) .................................................... 27
Figure 16: Sealant Applied to Backside............................................................................................. 28
Figure 18: Remove Battery Cap........................................................................................................ 29
Figure 19: Disconnect the Battery Connector ................................................................................... 29
Figure 20: Power Disconnected ....................................................................................................... 30
Figure 21: Proper Alignment to Slide Battery Out and In of Enclosure .............................................. 30
Figure 22: Reconnect Power Cables ................................................................................................. 31
MBUD-0266v1.3 Page v