Installation guide

LMU Users Guide
V1.0.6 December 10 2009
Copyright ©CalAmp DataCom Inc 2009
- 157 - CalAmp Proprietary & Confidential
Register
Description
8-Bit
LMU-1000™
LMU-2500™
LMU-4100™
170
BlueLocator Configuration Settings
Description:
This S-Register controls the settings of the
BlueLocator’s Bluetooth Adapter (BTA).
Settings:
Bit 0 & Bit 1 – Bluetooth Mode Control
0 = Not Active
1 = Set the BTA as the BlueLocator’s Host Port
2 = Set the BTA as the BlueLocator’s external Modem
Port
3 = Reserved
Bit 2
- Set = The BTA is discoverable and can be connected
to
- Cleared = The BTA is not discoverable and cannot
be connected to
Bit 3
- Set = The BTA will attempt to connect to the remote
device
- Cleared = The BTA will not attempt to connect to a
remote device
Bit 4
- Set = The BTA will use the Bluetooth Dial Up
Networking Profile
- Cleared = The BTA will use the Bluetooth Serial Port
Profile
Bit 5
- Set = The BTA is in low security mode (i.e. it does
not require a PIN to be paired to)
- Cleared = The BTA is in normal security mode (i.e. a
PIN is required for every new pairing)
X