Installation guide

LMU Users Guide

V1.0.6 December 10 2009

- 43 - CalAmp Proprietary & Confidential

5.4.4 Setting the network username and password

For some networks, the operator may require that a username and password be supplied

before the device is allowed to establish a data session with the network. The LMU can be

programmed to supply these values as part of the Dial-Up Networking negotiations. The

username is controlled by Parameter 2314 and the password is contained in Parameter 2315.

For instance, to set a username and password combination of ‘dummy’/’dummy’ you would

use:

AT$APP PARAM 2314,0,”dummy”

AT$APP PARAM 2315,0,”dummy”

Be advised that some usernames and passwords can be case sensitive, that is ‘Dummy’ is a

different username than ‘dummy’. Be sure you enter the values as they were provided to you

by your network operator otherwise the LMU might not be able to establish a data session.