Use and Care Manual

Operation

Fireplace Owner’s Manual

LTR50001006, Rev. Q

www

Upon completing the gas line connection,

a small amount of air will be in the lines.

take a few seconds for the lines to purge

themselves of this air.

Once the purging is complete, the burner

will light and operate as indicated in the

instruction manual. Subsequent lighting

of the appliance will not require purging

unless the gas supply has been disconnected.

Inspect the burner before each use of the appliance. If there is any

evidence that the burner is damaged, it must replaced before operat-

ing. Upon completing the gas line connection, a small amount of air will

for the lines to purge themselves of this air. Subsequent lighting of the

appliance will not require such purging.

Never allow the ON / OFF valve to remain in the open position without

placing a burning match on top of the burner FIRST!

You must have clear and easy access to the ON / OFF valve AFTER the

appliance is installed and connected to the gas supply in order to safely

turn of the burner.

Make sure the burner is in place prior to using the appliance. If the

manufacturer.

• Before operating smell all around the appliance area for gas odors

• Use only your hand to turn the manual gas control valve. Never use

tools. If the valve will not turn by hand, do not try to repair it. Call

• Do not use this appliance if any part has been under water. Imme-

If you do not

follow these

loss of life.

Operation