Use and Care Manual

P4, P5, and P6 Barbecue Grills
LTR50001137, Rev. K
Optional Grill Accessories
www.calamebbq.com
22
Use Turn part of your Cal Flame grill into a charcoal and gas grill.
Turn off the gas and wait for the grill to cool before setting the
Charcoal Tray in place.
Placement
1. Remove two grates (left or right side) and the ame tamers (the
angular metal pieces covering the burners). Do not remove the
burners.
2. Set the charcoal tray in the grilling area so that the notches in
the side rest on the round metal posts attached to the inside of
the grill area. The charcoal tray will resting over, but not ON, the
burners.
3. Place the ash screen in the Charcoal Tray.
Using the Charcoal Tray
The Charcoal Tray is designed and intended to
be used with plain charcoal. Quick-light char-
coal can produce excessive heat and may be
dangerous.
Make sure the drip tray is in the grill before
you begin.
Keep the hood up until you are ready to cook.
1. Arrange charcoal in the tray.
2. Replace the grates.
3. Ignite both burners under the Charcoal Tray and
turn them up to HIGH.
4. Let them burn until the charcoal remains lit
without help from the burners. This should take
7 to 10 minutes.
5. When the charcoal is ready, turn off the burners.
6. Lower the hood if you wish to use the grill as a
smoker.
Never use the Charcoal Tray over a
Sear Zone infrared burner.
NEVER use charcoal in a gas grill
without the charcoal tray. Doing so will
void your warranty.
Removal and Clean-up
When the grill has cooled and the charcoals are dead,
clean the grill as described in the grill owner’s manual.
Remove ash from the Charcoal Tray immediately after
use. Do not let it accumulate. Do not use the grill
again until charcoal ash has been removed from the
Charcoal Tray and the drip tray.
BBQ11859
Charcoal Tray