Instructions / Assembly
P4 and P5 Barbecue Grills
LTR50001137, Rev. F
Using Your Grill
www.calamebbq.com
19
Proper Burner Flame
The burner ame has been set in the factory and
should already be adjusted for proper height and
intensity. Periodically, you may wish to check each
burner’s ame for color, height, and intensity.
Remove the grill rack and the ame tamer over the
burner you want to inspect.
When the burner is operating properly, the ame will
appear between light to dark blue, with occasional
yellow bursts (due to impurities in propane -- this is
normal).
When the burner is set on high, the ame spread
out about ½” away from the side of the burner. (See
top gure at right.)
When the burner is set on low, the ame should be
just slightly visible when viewed from the side. (See
bottom gure at right.)
Note: Flame that is mostly yellow or golden in color
is often due to foreign matter in the burner. You
may need to clean your burners. See page 27 for
instruction on removing and cleaning your burners.
Flame Color and Height
Flame Adjustment
You can adjust the ame height to be higher or
lower according to your preferences. This may be
necessary if the ame goes out on the low ame
setting.
1. Light the burner and adjust the ame as low as
it can go without going out.
2. Remove the knob and insert a long at standard
screwdriver into the hole at the lower right side
of the valve.
3. Turn the ame adjustment screw to adjust the
ame to your preference.