Instructions / Assembly

P4, P5, and P6 Barbecue Grills
LTR50001137, Rev. K
Appendix
www.calamebbq.com
32
You will need:
• 6mm socket or nut driver
• Two to ve 1.9mm orices (depending on
your grill
• Pipe compound suitable for natural gas
b. Remove the locking pins from the end of the
burners.
The locking pins are accessible by removing the
drip tray and tilting the grill back. They can be
seen underneath the grill in the back. See gures
below.
c. Remove all burners by carefully lifting them up
and away from the valve orice.
d. Using a 6mm socket or nut driver, remove the
orice for the burner.
e. Apply a small amount of pipe compound to the
orice threads.
f. Screw in the orice until it is nger tight.
g. Tighten the orice with the 6mm wrench.
h. Repeat the above steps for the remaining burners.
i. Replace the burners, ame tamers, drip tray, and
grates.
You do not need to replace the locking pins. They
are used to keep the burners in place during
shipping and are not necessary to operate your
grill.
W
ID
T
H
W
ID
T
H
W
ID
T
H
W
ID
T
H
Minimum
Clearance
12” Minimum Distance
Between Grill and Side Burner
Minimum
Clearance
Screen Vents
W
ID
T
H
W
ID
T
H
WIDTH
DEPTH
WIDTH
WIDTH
DEPTH
WIDTH
WIDTH
WIDTH
DEPTH
DEPTH
DEPTH
HEIGHT
HEIGHT
HEIGHT
Burner
Locking Pin
Burner
Locking Pin
Orice
1. Replace the main burner orices
a. Remove the grates, ame tamers, and drip tray
from the grill. See gure below.
Step 2: Changing the burner orices