Owner`s manual

. A complete Parts List is available at www.MillerWelds.com
OM-253 392 Page 32
6-6. Calibrating Spoolmate 100
1 Material Thickness Plus (+)
Button
2 Left Adjustment Knob
3 Right Adjustment Knob
. Spoolmate 100 drive motors
are unique to this welding
power source. Motor calibra-
tion is necessary any time a dif-
ferent Spoolmate 100 is con-
nected to the Multimatic 200.
Connect Spoolmate 100 to unit. Cut
wire flush at nozzle.
Follow instructions in Section 6-3 to
enter the setup menu.
Press Material Thickness Plus (+)
button twice after entering setup to
enter the Spoolmate Calibration
menu.
To perform a Spoolmate calibration
12 in. runout test at 100 ipm, turn left
Adjustment knob and verify that a
(n) check mark appears next to
100 IPM. Be sure that wire is cut
flush at nozzle, then trigger the
Spoolmate 100.
Spoolmate will feed approximately
12 in. of wire through gun.
Cut wire flush at nozzle and meas-
ure run-out.
If wire is not 12 inches long, use left
Adjustment knob to increase or de-
crease the length of the run-out and
repeat the test.
To perform a Spoolmate calibration
12 in. runout test at 300 ipm, turn
right Adjustment knob and verify
that a (n) check mark appears next
to 300 IPM. Be sure tthat wire is cut
flush at nozzle, then trigger the
Spoolmate 100.
Spoolmate will feed approximately
12 in. of wire through gun.
Cut wire flush at nozzle and meas-
ure run-out.
If wire is not 12 inches long, use
right Adjustment knob to increase
or decrease the length of the
run-out and repeat the test.
Cycle through menu items using
the Material Thickness Plus (+) but-
ton or cycle unit power to save set-
tings and exit menu.
Ref. 249 632-E
ON/OFF
MATERIAL THICKNESS
AUTO−SET
WIRE/ROD/TUNGSTEN
ELECTRODE HOT
STICK
FLUX
CORED
SELF
SHIELDED
MIG
STAINLESS
MIG
STEEL
C25
MIG
STEEL
C100
MIG
ALUMINUM
TIG
LIFT-ARCt
REMOTE
TIG
LIFT-ARCt
ADJUST ADJUST
2
3
1