Owner`s manual

. A complete Parts List is available at www.MillerWelds.com
OM-253 392 Page 33
6-7. Viewing Burn-In Information
.
Burn-In information is for factory and service use only.
Follow instructions in Section 6-3 to enter the setup menu.
Press Material Thickness Plus (+) button three times after entering setup to enter the Burn-In information screen.
Burn-In information displays electrical information unique to the unit.
Cycle through menu items using the Material Thickness Plus (+) button or cycle unit power to save settings and exit menu.
6-8. Viewing Software Information
. Software information is for factory and service use only.
Follow instructions in Section 6-3 to enter the setup menu.
Press Material Thickness Plus (+) button four times after entering setup to enter the Software information screen.
Software information displays software information unique to the unit.
Cycle through menu items using the Material Thickness Plus (+) button or cycle unit power to save settings and exit menu.
6-9. Viewing Primary Power Information
. Primary Power information is for factory and service use only.
Follow instructions in Section 6-3 to enter the setup menu.
Press Material Thickness Plus (+) button five times after entering setup to enter the Primary Power Logs screen.
Primary Power Logs screen displays unit power on time.
Cycle through menu items using the Material Thickness Plus (+) button or cycle unit power to save settings and exit menu.
Notes
Work like a Pro!
Pros weld and cut
safely. Read the
safety rules at
the beginning
of this manual.