Owner`s manual

. A complete Parts List is available at www.MillerWelds.com
OM-253 392 Page 36
6-12. Performing A Factory Reset
1 Material Thickness Plus (+)
Button
2 Auto-Set Button
. A Factory Reset will reset the
primary log data, process log
data, and error log data. Con-
trast settings, motor calibration
settings, Spoolmate Calibra-
tion settings, Burn-In informa-
tion, and Software information
will all be retained.
Follow instructions in Section 6-3 to
enter the setup menu.
Press Material Thickness Plus (+)
button eight times after entering
setup to enter the Factory Reset
screen.
To perform a Factory Reset, press
the Auto-Set button. To exit this
screen without performing a factory
reset, press the Material Thickness
Plus (+) button.
Ref. 249 632-E
ON/OFF
MATERIAL THICKNESS
AUTO−SET
WIRE/ROD/TUNGSTEN
ELECTRODE HOT
STICK
FLUX
CORED
SELF
SHIELDED
MIG
STAINLESS
MIG
STEEL
C25
MIG
STEEL
C100
MIG
ALUMINUM
TIG
LIFT-ARCt
REMOTE
TIG
LIFT-ARCt
ADJUST ADJUST
2
1