Owner`s manual

OM-2218 Page 13
3-3. Volt-Ampere Curves
ST-186 864
Volt-ampere curves show minimum
and maximum voltage and amper-
age output capabilities of welding
power source. Curves of other set-
tings fall between curves shown.
3-4. Selecting A Location
1 Lifting Handles
Use handles to lift unit.
2 Hand Cart
Use cart or similar device to move
unit.
3 Rating Label
Use rating label to determine input
power needs.
4 Line Disconnect Device
Locate unit near correct input
power supply.
YSpecial installation may be
required where gasoline or
volatile liquids are present –
see NEC Article 511 or CEC
Section 20.
Movement
2
YDo not move or operate unit
where it could tip.
Airflow
4
3
18 in
(460 mm)
18 in
(460 mm)
ST-801 956-A
1
1