Specifications

– 9 –

DIRECTIONS FOR FIELD ASSEMBLING

AND WEATHERPFOOFING SECTIONS

1. Apply gasket material to the end of the ﬁ rst section

(blower, discharge, heater, ets). (See Fig. 1.)

NOTE: One roof cap is attached to a standing

seam on each section for shipping purposes only.

It will be necessary to remove this PRIOR TO SLID-

ING SECTIONS TOGETHER. Failure to do so may

damage seams, preventing proper seal.

2. Slide adjoining section against the tacky taped ﬁ rst

section. If bolt holes are provided, bolt the sections

together tightly. If bolt holes are not provided, use

furniture clamps to pull sections TIGHTLY together.

Sections, whether bolted or not, will be held togeth-

er and sealed by the standing seams and hugger

strips (Fig. 2), which will be attached later.

3. Once the sections are connected, apply caulking or

silicone sealant along the standing roof seam (Fig.

3) and side seams where the sections come togeth-

er. (Fig.1) It is mandatory to seal the roof and side

seams along the entire outside of the unit, and it is

strongly suggested that the seams also be sealed

along the inside of the unit, if possible.

4. Apply caulking material along the top of both sides

of the standing roof seam (Fig.4). Place roof cap

(Fig. 4) on top of the seam and secure it with two

rows of TEK screws (one down each side), spaced

approximately 8-10 inches apart down the entire

length of the seam.

5. Apply two strips of tacky tape (one down each side)

to the back side of each hugger strip (Fig. 2). Secure

hugger strip with two rows of TEK screws (one down

each side) spaced approximately 8-10 inches apart

down the entire length of the seam.

6. After hugger strips are installed, caulk around the

edges to complete the seal.

7. Repeat this process for each section as it is at-

tached. The number of sections varies by applica-

tion.

NOTE: HOOD REQUIRES ADDITIONAL, INSTALLER

PROVIDED, SUPPORT.