Operating instructions

ııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııı
www.fptgroup.com
Neo
Installation & Operating Instructions
Page 13
Drive
Size
A B D E F G H I J
mm in mm in mm in mm in mm in mm in mm in mm in mm in
2 257 10.1 220 8.67 200 7. 9 29 1. 1 238 9.37 188 7. 4 176 6.9 4.2 0.2 8.5 0.3
3 310 12.2 277 10.9 252 9.9 33 1. 3 256 10.1 211 8.3 198 7. 8 4.2 0.2 8.5 0.3
3.9 Mechanical Dimensions (IP66 Units)
3.10 Guidelines for Mounting (IP66 Units)
• Before mounting the drive, ensure that the chosen location meets the environmental condition requirements for
the drive shown in section 10.1
• The drive must be mounted vertically, on a suitable flat surface
• The minimum mounting clearances as shown in the table below must be observed
• The mounting site and chosen mountings should be sufficient to support the weight of the drive
Drive
Size
X
Above and Below
Y
Either Side
mm in mm in
4 200 7.87 10 0.39
5 200 7.87 10 0.39
6 200 7.87 10 0.39
7 200 7.87 10 0.39
Note:
Typical drive heat-losses are 3% of operating load conditions
Above are guidelines only and the operating ambient temperature of
the drive MUST be maintained at all times.
Using the drive as a template, or the dimensions shown above, mark the locations required for drilling
The drive should be mounted using M8 (Frame sizes 4 & 5) or M10 (Frame Sizes 6 & 7) mounting bolts
Control terminal torque settings: All Sizes: 0.8Nm
Power Terminal Torque Settings: Frame Size 2: 1.2-1.5Nm
I
J
D
B
E
H
G
A
F
X
X
X