Operating instructions

ııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııı
www.fptgroup.com
Neo
Installation & Operating Instructions
Page 21
5.3 Advanced Keypad Operation Shortcuts
Function When Display
Shows
Press Result Example
Fast selection of
Parameter Groups
Note: Parameter
Group Access must
be enabled
P1-14=101
Px-xx The next highest
Parameter group is
selected
Display shows P1-10
Press
Display shows P2-01
Px-xx The next lowest
Parameter group is
selected
Display shows P2-26
Press
Display shows P1-01
Select lowest Group
Parameter
Px-xx The first parameter of
a group is selected
Display shows P1-10
Press
Display shows P1-01
Set Parameter to
minimum value
Any numerical value
(whilst editing a
parameter value)
The parameter is set
to the minimum value
When editing P1-01
Display shows 50.0
Press
Display shows 0.0
Adjusting individual
digits within a
parameter value
Any numerical value
(whilst editing a
parameter value)
Individual parameter
digits can be adjusted
When editing P1-10
Display shows 0
Press
Display shows .0
Press
Display shows 10
Press
Display shows .1 0
Press
Display shows 1 10
etc
5.4 Drive Operating Displays
Display Status
stop
Drive mains power applied, but no Enable or Run signal applied
Auto-t
Motor Autotune in progress
H x.x Drive running, display shows output frequency (Hz) Whilst the drive is running, the following
displays can be selected by briefly pressing
the button on the drive. Each press of
the button will cycle the display through to
the next selection.
A x.x Drive running, display shows motor current (Amps)
P x.x Drive running, display shows motor power (kW)
C x.x Drive running, display shows customer selected
units, see parameters P2-21 and P2-22
t-2
Drive mains power not present, external 24 Volt control power supply present only
1 nh
Output power hardware inhibited, Safe Torque Off function activated. External links are required to
the STO inputs (terminals 12 and 13) as shown in section 4.8 Control Terminals Connection Diagram
P-def
Parameters reset to factory default settings
U-def
Parameters reset to User default settings
For drive fault code displays, refer to section 11.1 on page xx
+
+
+
+
+
etc...
+
+
+
+
+
+