Operating instructions

ııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııı
www.fptgroup.com
Neo
Installation & Operating Instructions
Page 29
17
O : Stop
C : Run Fwd
O : Stop
C : Run Rev
Digital Input 3 Analog Input 1 Preset Speed
Off Off Preset speed 1
On Off Preset speed 2
Off On Preset speed 3
On On Preset speed 4
External trip*
O : trip C : run
18
O : Stop
C : Run Fwd
O : Stop
C : Run Rev
Digital Input 3 Analog Input 1 Preset Speed
Off Off Preset speed 1
On Off Preset speed 2
Off On Preset speed 3
On On Preset speed 4
O : Decel ramp 1 (P1-04)
C : Decel ramp 2 (P2-25)
19
O : Stop
C : Run Fwd
O : Stop
C: Run Rev
Digital Input 3 Analog Input 1 Preset Speed
Off Off Preset speed 1
On Off Preset speed 2
Off On Preset speed 3
On On Preset speed 4
O : Selected speed ref
C : Preset speed 1 ..4
20 O : Stop
C: Run Fwd
O : Stop
C: Run Rev
Normally Open (N.O.)
Close to increase speed
Normally Open (N.O.)
Close to reduce speed
O : Selected speed ref
C: Preset speed 1
21 Normally Open (N.O.)
Close to run Fwd
Normally Closed (N.C.)
Open to stop
Normally Open (N.O.)
Close to run Rev
Analog 1 speed refer-
ence
O : Selected speed ref
C : Preset speed 1
The selected speed reference referred to in the above table is determined by the value set in P1-12 (Control Mode):
P1-12 (Control Mode) Selected Speed Reference
0 : Terminal mode Analog input 1
1 : Keypad Mode (uni-directional) Digital Potentiometer
2 : Keypad Mode (bi-directional) Digital Potentiometer
3 : User PID mode PID controller output
4 : Fieldbus Control Speed reference via Fieldbus
5 : Slave Mode Speed reference via Optibus
*Note: If a motor thermistor is to be connectd, this must be selected in P2-33.