Operating instructions

ııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııııı
www.fptgroup.com
Neo
Installation & Operating Instructions
Page 6
Declaration of Conformity
ERIKS Industrial Services Ltd hereby states that the
Fenner QD product range conforms to the relevant
safety provisions of the Low Voltage Directive
2006/95/EC and the EMC Directive 2004/108/EC and
has been designed and manufactured in accordance
with the following harmonised European standards:
EN 61800-5-1: 2003 Adjustable speed electrical
power drive systems. Safety
requirements. Electrical,
thermal and energy.
EN 61800-3 2
nd
Ed: 2004 Adjustable speed electrical
power drive systems. EMC
requirements and specific test
methods.
EN 55011:2007 Limits and Methods of
measurement of radio
disturbance characteristics
of industrial, scientific and
medical (ISM) radio-frequency
equipment (EMC).
EN60529:1992 Specifications for degrees
of protection provided by
enclosures.
Electromagnetic Compatibility
All Fenner drives are designed with high standards of
EMC in mind. All versions suitable for operation on
Single Phase 230 volt and Three Phase 400 volt
supplies and intended for use within the European
Union are fitted with an internal EMC filter. This EMC
filter is designed to reduce the conducted emissions
back into the supply via the power cables for
compliance with harmonised European standards.
It is the responsibility of the installer to ensure that the
equipment or system into which the product is
incorporated complies with the EMC legislation of the
country of use. Within the European Union, equipment
into which this product is incorporated must comply
with the EMC Directive 2004/108/EC. When using an
Fenner drive with an internal or optional external filter,
compliance with the following EMC Categories, as
defined by EN61800-3:2004 can be achieved:
Drive Type /
Rating
EMC Category
Cat C1 Cat C2 Cat C3
1 Phase,
230 Volt
Input
No additional filtering required.
Use shielded motor cable.
3 Phase,
400 Volt
Input
Use exter-
nal filter
No additional filtering
required
Use shielded motor cable
Note
For motor cable lengths greater than
100m, an output dv / dt filter must be
used. For further information contact
your Fenner distributor.
Vector speed and torque control modes
may not operate correctly with long
motor cables and output filters. It is
recommended to operate in V/F mode
only for able length exceeding 50m
All rights reserved. No part of this User Guide may be
reproduced or transmitted in any form or by any means,
electrical or mechanical including photocopying, recording or
by any information storage or retrieval system without
permission in writing from the publisher.
Copyright ERIKS Industrial Services Ltd © 2011
ERIKS Industrial Services Ltd, Amber Way, Halesowen,
West Midlands, B62 8WG
The manufacturer accepts no liability for any consequences
resulting from inappropriate, negligent or incorrect
installation, or adjustment of the optional operating
parameters of the drive or from mismatching of the drive to
the motor.
The contents of this User Guide are believed to be correct
at the time of printing. In the interest of a commitment to a
policy of continuous improvement, the manufacturer
reserves the right to change the specification of the product
or its performance or the contents of the User Guide
without notice.
All Fenner QD Series products carry a 2-year warranty, valid
from the date of manufacture. This date is visible on the
product rating label.