Repair manual

green/black
SELECTING THE MAIN BEARING SHELLS (GROUND J OURNALS)
If the journals have been ground, the procedure described so far cannot be applied.
In this case, it is necessary to check that the new diameter of the journals is as shown in the table and to mount the only type
of bearing shell envisaged for the relevant undersizing.
-0.127
1 2 3
99.843
99.852
green/black
green/black
green/black
green/black
green/black
green/black
red/black
red/black
green/black green/black
green/black
red/black
red/black
red/black
red/black
green/black
green/black
99.853
99.862
99.863
99.873
1
2
3
red/black =
3.173 to 3183 mm
green/black =
3.184 to 3.193 mm
-0.254
1 2 3
99.726
99.746
red red red
red red red
red =
3.237 to 3.247 mm
-0.508
1 2 3
99.468
99.508
red red red
red red red
red =
3.364 to 3.374 mm
Figure 28
SECTION 4 - OVERHAUL AND TECHNICAL SPECIFICATIONS
21
F3C CURSOR ENGINES
Print P2D32C005 E Base - May 2007