Hardware manual
32
FUJITSU SEMICONDUCTOR CONFIDENTIAL
MB96630 Series
DS704-00012-1v0-E
ELECTRICAL CHARACTERISTICS
1. Absolute Maximum Ratings
Parameter Symbol Condition
Rating
Unit Remarks
Min
Max
Power supply
voltage*
1
V
CC
-
V
SS
-
0.3
V
SS
+ 6.0 V
Analog power supply
voltage*
1
AV
CC
-
V
SS
-
0.3
V
SS
+ 6.0 V V
CC
= AV
CC
*
2
Analog reference
voltage*
1
AVRH -
V
SS
-
0.3
V
SS
+ 6.0 V
AV
CC
≥ AV R H ,
AVRH ≥ AV
SS
Input voltage*
1
V
I
-
V
SS
-
0.3
V
SS
+ 6.0 V
V
I
≤ V
CC
+
0.3V*
3
Output voltage*
1
V
O
-
V
SS
-
0.3
V
SS
+ 6.0 V
V
O
≤ V
CC
+
0.3V*
3
Maximum Clamp
Current
I
CLAMP
- -4.0 +4.0 mA
Applicable to
general purpose
I/O pins *
4
Total Maximum
Clamp Current
Σ|I
CLAMP
| - - 21 mA
Applicable to
general purpose
I/O pins *
4
"L" level maximum
output current
I
OL
- - 15 mA
"L" level average
output current
I
OLAV
- - 4 mA
"L" level maximum
overall output current
ΣI
OL
- - 52 mA
"L" level average
overall output current
ΣI
OLAV
- - 26 mA
"H" level maximum
output current
I
OH
- - -15 mA
"H" level average
output current
I
OHAV
- - -4 mA
"H" level maximum
overall output current
ΣI
OH
- - -52 mA
"H" level average
overall output current
ΣI
OHAV
- - -26 mA
Power
consumption*
5
P
D
T
A
= +125°C - 396
*6
mW
Operating ambient
temperature
T
A
- -40 +125
*7
°C
Storage temperature
T
STG
-
-55
+150
°C
*1: This parameter is based on V
SS
= AV
SS
= 0V.
*2: AV
CC
and V
CC
must be set to the same voltage. It is required that AV
CC
does not exceed V
CC
and that the
voltage at the analog inputs does not exceed AV
CC
when the power is switched on.
*3: V
I
and V
O
should not exceed V
CC
+ 0.3V. V
I
should also not exceed the specified ratings. However if the
maximum current to/from an input is limited by some means with external components, the I
CLAMP
rating
supersedes the V
I
rating. Input/Output voltages of standard ports depend on V
CC
.
*4: • Applicable to all general purpose I/O pins (Pnn_m).
• Use within recommended operating conditions.
• Use at DC voltage (current).
• The +B signal should always be applied a limiting resistance placed between the +B signal and the
microcontroller.
• The value of the limiting resistance should be set so that when the +B signal is applied the input current to
the microcontroller pin does not exceed rated values, either instantaneously or for prolonged periods.