Hardware manual

39
FUJITSU SEMICONDUCTOR CONFIDENTIAL
MB96630 Series
DS704-00012-1v0-E
Parameter Symbol
Pin
name
Conditions
Value
Unit Remarks
Min
Typ
Max
Power supply
current in Stop
mode
*3
I
CCH
Vcc
-
- 20 60
µA
T
A
= +25°C
- - 880
µA
T
A
=+105°C
- - 1845
µA
T
A
=+125°C
Flash Power
Down current
I
CCFLASHPD
- - 36 70
µA
Power supply
current
for active Low
Voltage
detector*
4
I
CCLVD
Low voltage
detector enabled
- 5 -
µA
T
A
= +25°C
- - 12.5
µA
T
A
=+125°C
Flash Write/
Erase current*
5
I
CCFLASH
-
- 12.5 - mA T
A
= +25°C
- - 20 mA T
A
=+125°C
*1: The power supply current is measured with a 4MHz external clock connected to the Main oscillator and
a 32kHz external clock connected to the Sub oscillator. See chapter “Standby mode and voltage regulator
control circuit” of the Hardware Manual for further details about voltage regulator control. Current for "On
Chip Debugger" part is not included. Power supply current in Run mode does not include Flash Write / Erase
current.
*2: The power supply current in Timer mode is the value when Flash is in Power-down / reset mode.
When Flash is not in Power-down / reset mode, I
CCFLASHPD
must be added to the Power supply current.
The power supply current is measured with a 4MHz external clock connected to the Main oscillator and a
32kHz external clock connected to the Sub oscillator. The current for "On Chip Debugger" part is not
included.
*3: The power supply current in Stop mode is the value when Flash is in Power-down / reset mode.
When Flash is not in Power-down / reset mode, I
CCFLASHPD
must be added to the Power supply current.
*4: When low voltage detector is enabled, I
CCLVD
must be added to Power supply current.
*5: When Flash Write / Erase program is executed, I
CCFLASH
must be added to Power supply current.