Hardware manual
5
FUJITSU SEMICONDUCTOR CONFIDENTIAL
MB96630 Series
DS704-00012-1v0-E
PRODUCT LINEUP
Features
MB96630
Remark
Product Type
Flash Memory Product
Subclock
Subclock can be set by software
Dual Operation Flash Memory
RAM
-
64.5KB + 32KB 10KB MB96F633R, MB96F633A
Product Options
R: MCU with CAN
A: MCU without CAN
128.5KB + 32KB
16KB
MB96F635R, MB96F635A
256.5KB + 32KB
24KB
MB96F636R
384.5KB + 32KB
28KB
MB96F637R
Package
LQFP-80
FPT-80P-M21
DMA
4ch
USART
5ch
LIN-USART 0/2/4/5/7
with automatic LIN-Header
transmission/reception
Yes (only 1ch) LIN-USART 0
with 16 byte RX-and
TX-FIFO
No
I
2
C
2ch
I
2
C 0/1
8/10-bit A/D Converter 21ch
AN 2 to 4/6 to 8/
10 to 12/15 to 17/20 to 28
with Data Buffer
No
with Range Comparator Yes
with Scan Disable
Yes
with ADC Pulse Detection
No
16-bit Reload Timer (RLT)
3ch
RLT 0/1/6
16-bit Free-Running Timer (FRT)
3ch
FRT 0 to 2
16-bit Input Capture Unit (ICU)
7ch
(1 channel for LIN-USART)
ICU 0/1/4 to 7/9
(ICU 9 for LIN-USART)
16-bit Output Compare Unit (OCU) 7ch
OCU 0 to 4/6/7
(OCU 4 for FRT clear)
8/16-bit Programmable Pulse Generator
(PPG)
15ch (16-bit) / 20ch (8-bit) PPG 0 to 4/6 to 15
with Timing point capture
Yes
with Start delay
Yes
with Ramp
No
Quadrature Position/Revolution Counter
(QPRC)
2ch QPRC 0/1
CAN Interface 1ch
CAN 0
32 Message Buffers
External Interrupts (INT)
15ch
INT 0 to 13/15
Non-Maskable Interrupt (NMI)
1ch
Real Time Clock (RTC)
1ch
I/O Ports
62 (Dual clock mode)
64 (Single clock mode)
Clock Calibration Unit (CAL)
1ch
Clock Output Function 2ch
Low Voltage Detection Function Yes
Low voltage detection
function can be
disabled by software
Hardware Watchdog Timer
Yes
On-chip RC-oscillator
Yes
On-chip Debugger
Yes
Note: All signals of the peripheral function in each product cannot be allocated by limiting the pins of package.
It is necessary to use the port relocate function of the general I/O port according to your function use.