Hardware manual

63
FUJITSU SEMICONDUCTOR CONFIDENTIAL
MB96630 Series
DS704-00012-1v0-E
 MAJOR CHANGES IN THIS EDITION
A change on a page is indicated by a vertical line drawn on the left side of that page.
Page
Section
Change Results
- - PRELIMINARY → Data sheet
2
FEATURES
Changed the description of “System clock”
Up to 16 MHz external clock for devices with fast clock input
feature
→
Up to 8 MHz external clock for devices with fast clock input
feature
4
Changed the description of “External Interrupts”
Interrupt mask and pending bit per channel
→
Interrupt mask bit per channel
Changed the description of “Built-in On Chip Debugger”
- Event sequencer: 2 levels
→
- Event sequencer: 2 levels + reset
5
PRODUCT LINEUP
Added the Product
Changed the Remark of RLT
RLT 0/1/6 Only RLT6 can be used as PPG clock source
→
RLT 0/1/6
6
BLOCK DIAGRAM
Deleted the block of RLT6 from PPG block
Changed the RLT block
2ch
→
0/1/6 3ch
8
PIN DESCRIPTION
Changed the Description of PPGn_B
Programmable Pulse Generator n output (8bit)
→
Programmable Pulse Generator n output (16bit/8bit)
13
I/O CIRCUIT TYPE
Changed the figure of type B
Changed the Remarks of type B
(CMOS hysteresis input with input shutdown function,
I
OL
= 4mA, I
OH
= -4mA, Programmable pull-up resister)
→
(CMOS level output (I
OL
= 4mA, I
OH
= -4mA), Automotive
input with input shutdown function and programmable pull-up
resistor)
14 Changed the figure of type G
17
MEMORY MAP
Changed the START addresses of Boot-ROM
0F:E000
H
→
0F:C000
H