Specifications
Page 14 2008 Fireplace and Firepit Owner’s Manual
LTR20081006, Rev. A
Maintenance
Maintenance
Inspect the appliance before initial use. Clean the
appliance at least annually and have it inspected by a
qualied eld service person.
Periodically remove the logs and examine the burner.
If the burner is dirty, clean it with a soft wire brush. Also
examine the area around the burner air shutter. Remove
any dirt or debris in this area. This will ensure long life
and trouble-free operation.
Periodically check the hose connecting the LP gas
cylinder to ensure it is not damaged in any way.
Carbon (soot) may build up on the surfaces of the logs
with heavy use. This is more likely to occur with LP gas.
Clean soot off the surface of the logs periodically to
prevent excessive buildup.
To clean the logs, be sure the re is out, the gas supply
is turned off and the logs are cool to the touch. The soot
can then be brushed of with a dry bristle brush or cloth.
Take care while cleaning the logs as they can become
damaged if mishandled.
Periodically check the hose connecting the LP gas
cylinder to ensure it is not cracked or damaged in any
way. All natural gas hook-ups should be serviced and
inspected only by qualied installers only.
The easiest way to clean the repit or replace is to let
the repit/replace cool completely off.
With a wood burning replace, remove the steel grate
and sweep out the ashes and leftover kindling.
With a gas repit or replace, spray the enclosure
off with water. Note: Do NOT spray water directly
onto the burner and pilot light of the gas replace.
When not in use and after cooling, cover your repit with
our full length, zippered side canvas cover. The cover
will help protect your repit/replace from detrimental
effects of weather and environmental pollutants (see
your local Cal Flame dealer for details).
Before installing the cover make sure the unit is shut off,
that the gas lines are disconnected and that the unit has
had sufcient time to cool. Install the cover and use the
tie-down straps to secure it tightly to the unit to prevent
the wind from blowing it off.
•
•