Specifications

2008 Fireplace and Firepit Owner’s Manual Page 7
LTR20081006, Rev. A
Installation and Assembly
Fireplace Log Set Placement
The log set, log grate and crushed lava rock are shipped
together on applicable models. Remove the log set and
un-pack all components. The logs are fragile -- use care
when handling.
Do not install the log set in an unvented appliance.
Once the replace is in position, level and safely hooked
up to the proper fuel supply, install the log grate over the
plate burner.
Place the lava rock around the at burner plate. DO NOT
place the lava rock on the burner plate as it will affect the
ow of the ame.
Log placement for
FRP-1000, 1500, 2000, 3000, 3100
Place the ceramic re logs on the grate. Start by laying
one log in the centre of the grate length wise.
Lay the other logs (quantity may vary by unit type) over
the rst log as shown below.
NOTE: Be sure unit is cool before touching any of
the components.
For the FRP-4300 place two logs length wise in the
grate and position remaining logs over them in an
angled position as shown in Placement Picture for
FRP-4300. Ensure the logs are place securely to avoid
any movement.
Log Placement for FRP-4300