Technical data

312013 15
Operation
Run Mode
When the Informer display is in Run Mode, the current
flow rate, batch totalizer, maintenance totalizer, and
grand totalizer values can be viewed for the flow meter
the Informer display is connected to.
cc/min
Flow Rate Monitoring Screen
Alarms
There are two ways the Informer display can be used
to notify a user when the Batch Totalizer Target, Main-
tenance Totalizer Target, or the Flow Rate Maximum or
Minimum Thresholds have been reached. There is an
alert on the Informer screen in the form of a flashing
icon when the user is in Run Mode and viewing the
related screen information. For example, the flow rate
icon will flash in the flow rate, Run mode screen when
a threshold value is reached.
Alarm outputs can also be enabled so the Informer
display will send a signal to turn on an external alarm
to signal an alarm condition. This enables the user to
be alerted to an alarm condition regardless of which
Informer screen is being viewed. See Alarm Outputs
on page 18.
Button Functions in Run Mode
Button
Function
Flow Rate:
Press the up arrow button to display the current flow rate. If either the flow rate maximum or the
flow rate minimum threshold values are greater than zero, holding the button down will toggle
the display between the flow rate maximum and the flow rate minimum threshold values entered
in Setup Mode. Refer to D2 and D3 setup parameter information on page 18. The flow rate icon
will flash in this screen when a threshold value is reached.
Batch Totalizer:
Press the down arrow button to display the current batch totalizer. If the batch target value is
greater than zero, holding the button down will display the target value entered in Setup Mode.
Refer to A2 setup parameter information on page 17. The batch totalizer icon will flash in this
screen when the target value is reached.
Reset Batch Totalizer
Pressing the reset button for about one-half second while the batch totalizer is displayed will
either set the totalizer to zero if the totalizer is set to count up or preset the totalizer to the target
value if the totalizer is set to count down.
Maintenance Totalizer:
Press the enter button to display the current maintenance totalizer. If the maintenance target
value is greater than zero, holding the button down will display the target value. The mainte-
nance totalizer icon will flash in this screen when the target value is reached.
Reset Maintenance Totalizer
Pressing the reset button for about one-half second while the maintenance totalizer is displayed
will set the totalizer to zero.
Grand Totalizer:
Press the enter and down arrow buttons simultaneously to display the current grand totalizer.
Enter Setup Mode:
Hold down the enter button, then press the up arrow button to enter Setup Mode.
NOTE: The battery icon will flash to alert you if a low battery alarm occurs, regardless of which Run Mode screen
is displayed.